Samsung RF28 Série Guide D'utilisation page 41

Autofill Pitcher
Untitled-3 41
Press and hold Fridge for 3 seconds to turn this function on. Open
the left door of the fridge, and then insert the water pitcher. Close
the door and the water pitcher will be filled with water up to the
preset level.
To turn the function off, press and hold Fridge again for
3 seconds.
NOTE
• By default, Autofill Pitcher is disabled. Enable this function
after you have installed the water line.
• If you open the door or push the dispenser lever, this function
is stopped temporarily.
• The Autofill Pitcher indicators blink if there is a leak. This may
occur because the water pitcher overflows, or the water-line or
water-level sensor fails. If this is the case, follow these steps.
a. Open the rubber cap and drain water.
b. When draining is complete, the indicators stop blinking and
turn solid.
c. Close the rubber cap.
• If the indicators continue to blink, this might be a system
failure. Contact a local service center.
English 41
2019-05-15 4:09:36