Leica Microsystems FS C Manuel D'utilisation page 34

9. Accessories
Bullet Holder
To assemble the bullet holder (36.1), slide the
adapter sleeve in the segment guide down-
wards to the "0" marking. Guide the bullet hold-
er vertically to the adapter sleeve and fasten it
with the knurled screw (36.2). Adjust the adapter
sleeve horizontally again (slide upwards to the
"90" marking) and press the rubber-coated
pressure plate (37.3) into the conical bore of the
adapter sleeve. After unscrewing the clamping
screw (37.2), you can move the centering insert
(37.3) horizontally in the bullet holder, thus ad-
justing it to the length of the projectiles
currently being compared.
Fig. 36 Adjustable holder with bullet holder (assembly)
1 Bullet holder
2 Fastening screw
34
Before removing the unit, be sure there is
sufficient distance between it and the objec-
tive.
Fig. 37 Adjustable holder with bullet holder
1 Rubber-coated pressure plate
2 Clamping screw
3 Centering insert with spring system
4 Bullet
1
2
Caution:
1 4 3
2