Troubleshooting - Emjoi Micro-Pedi AP-3RP Mode D'emploi

❐ Do not use any caustic or abrasive agents to clean the
device. These could damage the surface.
1. For hygienic reasons, the device should be cleaned after
every use.
2. Remove the roller from the device (see the "Changing
the Roller" section) and brush off any fl akes of skin which
may remain on it.
3. Hold the head of the device under running water for 5
to 8 seconds.
4. Dry the device thoroughly.
5. Insert the roller again and place the protective cover on
the device.
6. Store the device and accessories in a dry place that is out
of the reach of children.

Troubleshooting

Problem
The device is not
working.
The device stops
during treatment.
The calluses are
not being properly
removed.
Possible cause/solution
Are the batteries too weak or incor-
rectly inserted? If necessary, insert
new batteries (see the "Inserting/
Changing Batteries" section).
Do not use excessive pressure. For
safety reasons, the device stops auto-
matically when too much pressure is
applied on the skin.
The roller is worn. Replace it (see the
"Changing the Roller" section).
31