Preparation; Installing The Plasma Display; Moving The Plasma Display; Attaching The Pioneer Stand - Pioneer PDP-6010FD Mode D'emploi

Preparation

Chapter 5
Preparation

Installing the plasma display

Over 50 cm
Over
(19 11/16 inches)
10 cm
(3 15/16
inches)
Location
• Avoid direct sunlight. Maintain adequate ventilation.
Note
• Allow enough space around the upper and back parts when
installing to ensure adequate ventilation of the rear of the unit.

Moving the plasma display

Because the plasma display is heavy, be sure to have someone
help you when moving it.
(PDP-6010FD)
(PDP-5010FD)
Caution
When installing on a rack, etc., hold the plasma display.

Attaching the Pioneer stand

The plasma display comes with the Pioneer table top stand. You
can also install the display on a rack by detaching the stand. The
method for attaching/detaching the stand varies depending on
the product.
Caution
• This product can be used only with the attached stand. Using
other stands can result in instability, possibly causing injury.
• The weight of a 60 inch plasma display is about 55.5 kg
(122.4 lbs.) and a 50 inch about 38.5 kg (84.9 lbs.), it has no
depth, and is unstable. Therefore, at least two people must
assemble and install it.
Assembling the stand (PDP-6010FD only)
1 Turn the base cover over so the underside is facing
up.
2 Insert the stand pipes into the base cover.
Insert stand pipe (R) into the side marked "R" and stand pipe
(L) into the side marked "L".
3 Tighten the screws
stabilize the stand pipes.
➀
Screws
(M5 x 10 mm: black)
Stand
pipe with "R"
inscribed
Front
Completed
Table top stand
(M5 x 10 mm: black) to
➀
Screws
(M5 x 10 mm: black)
Rear
Stand
pipe with "L"
inscribed
Base cover
Sheet
05
17
En