Kinetec Spectra Essential Mode D'emploi page 15

Electrical connection: SAFETY FIRST.
The KINETEC Spectra Essential Machine is a type B class I device I.
Before connecting the device to the power supply, check that the
mains voltage matches that shown on the identification plate (100-240
V~ 50-60Hz).
Connect the hand control (4)
Connect the power supply cable (18).
IMPORTANT
Check that the electrical socket is in good condition and is suitable for
the splint power supply cord. The latter complies with current standards
and has a grounding socket.
The plug may be connected to any standard socket.
The socket must however have a grounded pin.
To connect the power supply, only use the original cable supplied with
the machine.
Check that the cables remain free around the device so that they do
not get damaged.
Check that the machine is not damaged, in particular the protective
housings.
Starting the unit
Switch on the unit (9).
The display comes on, the machine carries out a self-test, and then the display shows:
Your KINETEC Spectra Essential is ready to be used.
Changing the display language
Press the following buttons simultaneously:
change the display language.
Press the
then switch the machine off and then on again to apply the changed display language.
Available languages: English, French, German, Italian and Spanish.
START/STOP/REVERSE function
As with all KINETEC systems, KINETEC Spectra is equipped with a START/STOP/REVERSE function.
When the unit is running, the display reads RUN.
Press the
Press the
For optimum safety, always give the hand control to the patient before starting the system.
Procedure to stop the machine:
To stop the machine's movement: Press the
To switch power off: press the ON / OFF switch (9).
Locking the hand control setting
The hand control allows the patient to control the machine as appropriate.
Simultaneously press the
The display reads LOCK, you cannot change the parameters, if you try the display reads LOCK SOFT, To
unlock the hand control, simultaneously press the same keys, The display reads UNLOCK.
We recommend that you lock the hand control when you give it to the patient.
Note: The hand control locking is preserved when you switch the unit ON/OFF.
Spectra Essential
button to confirm,
key of the hand control. The movement stops.
key of the hand control. The movement starts in the opposite direction.
and
and , followed by
Caution:
button.
keys to lock the hand control,
EN
9
18
4
EXT
30 STOP
or
FLEX
15 70
to
3/9