Installation And Maintenance - Brita AquaGusto 100 Instructions D'utilisation

1. Installation and maintenance

! Caution: Prior to installation, read the operating and safety information (Chapter 2).
1.1. Installation of the water tank fi lter and of the exchange reminder
Remove the foil and rinse the water tank filter with water
A
before installation.
Place the water tank filter at the bottom of the water tank
B
and fill the water tank with cold drinking water.
! Caution:
Do not force the water tank filter in the water tank: before installing the
water tank filter, make sure that it will be possible to get it later out of the water tank
easily by hand or using an appropriate tool.
Remove the film of the exchange reminder and place the exchange reminder on
C
the water tank or other visible part of the coffee machine.
Note: do not place the exchange reminder against a source of warmth.
To activate fully squeeze the button and within 2 minutes a red activation line will
D
appear. If not, immediately re-squeeze the button fully. When the activation line
appears, the indicator is armed and ready to use. The red dye will continue to
progress until the maximum elapsed time has been reached.
For optimal limescale protection and best taste results, the water tank filter
E
should be placed in the water tank the evening before the utilization of the machine.
Always refill the water tank the evening before the next utilization.
1.2. Maintenance
• Clean the water tank regularly.
• The water in the tank must be used up or changed after maximum 1 day.
• If the coffee machine is not in use for a longer period, we recommend that the filter
be left in the water tank and the unfiltered water be poured out. Before using the
coffee machine again, remove the filter from the water tank, clean it and repeat the
stages in Chapter 1.1.
11