Jacuzzi frame Manuel D'utilisation Et D'entretien page 60

If there are no errors, the steam temperature setting screen
will appear:
20
1
2
If a few seconds pass without pressing any key, the number
under the drops will start to flash, which indicates that the regula-
tion of the Turkish bath duration has been activated: press the "on/
off" key to return to temperature regulation.
The pre-set value is indicated by the "two drop" symbol (see
below); to select other values, use keys "<" or ">" and press the
"on/off" key to confirm the selected value (a line appears below
the symbol).
Each temperature value is represented by a symbol with one
or more drops:
- one drop (temperature of 35-40 °C); it can be considered the
initial step towards building up to a real humid vapour bath.
The low temperature enables initial heating up of the body and
the opening of skin pores.
- two drops (temperature of 40-45 °C); normally associated
with massages, at this temperature, the Turkish bath allows
for relaxation and true wellness. The vapour pressure levels
are high.
- three drops (temperature of 45-48 °C); vapour pressure lev-
els are close to 100%. Sweating is intense, resulting in natural
detoxication of the body.
It is possible to vary the selected value also after the function
has been activated; using keys "<" or ">, a line appears under the
drops to indicate which temperature value can be selected (to con-
firm the selected value, press "on/off").
To activate the Turkish bath with the pre-set values (tempera-
ture and duration) do not press any key and wait for the water to be
completely filled in the steam generator: at the end of this phase the
function will start automatically.
1
ATTENTION! If the thermometer symbol does not appear
and the only selectable value is the one with three drops
(see figure below), the temperature probe may be faulty;
this error is shown on the display also by the message "AL2",
which will continue to appear at intervals.
Is it still possible to use the Turkish bath, but only at the
maximum steam temperature!
Contact a Jacuzzi® service centre.
20
After adjusting the temperature and pressing the "on/off"
key, the number under the drops will flash, indicating that the
regulation of the Turkish bath duration has been activated.
20
1
You can set a time between a minimum of 5 minutes and a
maximum of 45, using the keys "<" or ">" and then pressing the
"on/off" key.
If you do not want to change the displayed value, simply
press the "on/off" key.
It is possible to vary the selected value, even when the func-
tion has been activated, by pressing the "on/off" key (the number
flashes) and using the keys "<" or ">".
To activate the Turkish bath with the pre-set values (tempera-
ture and duration) do not press any key and wait for the water to be
completely filled in the steam generator: at the end of this phase the
function will start automatically.
60
AL2
1
2