Additional Information; Troubleshooting - Pioneer SX-319V Mode D'emploi

Additional information

Chapter 10:
Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie
in another component. Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest
Pioneer authorized service center or your dealer to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
Problem
The power does not turn on.
No sound is output when a
function is selected.
Considerable noise in radio
broadcasts.
Broadcast stations cannot be
selected automatically.
No sound from surround or
center speakers.
Remedy
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the
rear panel. This could cause the receiver to shut off automatically.
• If the power shuts off automatically, take the unit to your nearest
Pioneer authorized service center or your dealer for servicing.
• Make sure the component is connected correctly (refer to
Connecting up on page 7).
• Press MUTE on the remote control to turn muting off.
• Press SIGNAL SEL to select the proper input signal (see Choosing
the input signal on page 29).
• Connect the antenna (page 14) and adjust the position for best
reception.
• Route any loose cables away from the antenna terminals and wires.
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall (or connect an outdoor FM antenna).
• Connect an additional internal or external AM antenna (page 14).
• Turn off equipment causing interference or move it away from the
receiver (or move antennas farther away from equipment causing
noise).
• Connect an outdoor antenna (refer to page 14).
• Connect the speakers properly (refer to page 15).
• Refer to Speaker setting on page 30 to check the speaker settings.
• Refer to Channel level on page 31 to check the speaker levels.
10
37
En