Pioneer SX-319V Mode D'emploi page 28

05 Listening to your system
Setting
DRC
(Dynamic Range
Control)
LFE ATT
(LFE Attenuate)
HDMI
(HDMI Audio)
A.DLY
(Auto Delay)
e
C.WIDTH
(Center Width)
(Applicable only when
using a center speaker)
e
DIMEN.
(Dimension)
e
PNRM.
(Panorama)
a. You can change the MIDNIGHT/LOUDNESS options at any time by using MIDNIGHT button.
b. You can change the Sound Retriever feature at any time by using S.RETRIEVER button.
c. This setting works only with dual mono encoded Dolby Digital and DTS soundtracks.
d. This feature is only available when the connected display supports the automatic audio/video synchronizing
capability ('lip-sync') for HDMI. If you find the automatically set delay time unsuitable, set A.DLY to OFF and
adjust the delay time manually. For more details about the lip-sync feature of your display, contact the
manufacturer directly.
e. Only available with 2-channel sources in DOLBY PLII MUSIC mode.
28
En
What it does
Adjusts the level of dynamic range for movie soundtracks
optimized for Dolby Digital and DTS (you may need to use
this feature when listening to surround sound at low
volumes).
Some Dolby Digital and DTS audio sources include ultra-
low bass tones. Set the LFE attenuator as necessary to
prevent the ultra-low bass tones from distorting the sound
from the speakers.
The LFE is not limited when set to 0 dB, which is the
recommended value. When set to –10 dB, the LFE is
limited by the respective degree. When OFF is selected, no
sound is output from the LFE channel.
Specifies the routing of the HDMI audio signal out of this
receiver (amp) or through to a TV or flat panel TV. When
THRU is selected, no sound is output from this receiver.
This feature automatically corrects the audio-to-video delay
between components connected with an HDMI cable. The
audio delay time is set depending on the operational status
of the display connected with an HDMI cable. The video
delay time is automatically adjusted according to the audio
d
delay time.
Spreads the center channel between the front right and left
speakers, making it sound wider (higher settings) or
narrower (lower settings).
Adjusts the surround sound balance from front to back,
making the sound more distant (minus settings), or more
forward (positive settings).
Extends the front stereo image to include surround
speakers for a 'wraparound' effect.
Option(s)
OFF
MAX
MID
LFEATT 0 (0 dB)
LFEATT 10 (–10 dB)/
LFEATT ** (OFF)
AMP
THRU
OFF
ON
0 to 7
Default: 3
–3 to +3
Default: 0
OFF
ON