Using A Bi-Amplifier Connection - Sony STR-DA4300ES Mode D'emploi

Using a bi-amplifier
connection
If you are not using surround back speakers,
you can use the SUR BACK SPEAKERS
terminals for the front speakers for use with a
bi-amplifier connection.
To connect speakers
Front speaker
(R)
Hi
Lo
Connect the jacks on the Lo (or Hi) side of the
front speakers to the FRONT SPEAKERS A
jacks, and connect the jacks on the Hi (or Lo)
side of the front speakers to the SUR BACK
SPEAKERS terminals. Make sure that metal
fittings of Hi/Lo attached to the speakers have
been removed from the speakers. Not doing so
may cause a malfunction of the receiver.
To set up speakers
Set "Sur Back Assign" to "BI-AMP" in the
Speaker settings menu. The same signals
output from the FRONT SPEAKERS A jacks
can be output from the SUR BACK
SPEAKERS terminals by setting "Sur Back
Assign" to "BI-AMP."
110 GB
Notes
• You cannot use the FRONT SPEAKERS B jacks
for a bi-amplifier connection.
• When you use the auto calibration function, make
the bi-amplifier settings before you perform auto
calibration.
• If you make the bi-amplifier settings, the speaker
level, balance, and equalizer settings of the
surround back speakers become invalid, and those
of the front speakers are used.
• Signals output from the PRE OUT jacks are used
with the same settings as those of the SPEAKERS
terminals.
Front speaker
(L)
Hi
Lo