Remote Commander - Sony STR-DA4300ES Mode D'emploi

Remote commander

You can use the supplied remote RM-AAL011
to operate the receiver and to control the Sony
audio/video components that the remote is
assigned to operate (page 124).
RM-AAL011
Name Function
A AV ?/1 (on/
Press to turn on or off the audio/
standby) video components that the
remote is assigned to operate
(page 124).
If you press the ?/1 (B) at the
same time, it will turn off the
receiver and other Sony
components (SYSTEM
STANDBY).
Note
The function of the AV ?/1
switch changes automatically
each time you press the input
button (C).
B ?/1 (on/
Press to turn the receiver on or
standby) off.
If ZONE 2 is selected, only the
main receiver is turned on or off
with this button. To turn off all
components including an
amplifier in zone 2, press ?/1
and AV ?/1 (A) at the same
time (SYSTEM STANDBY).
C Input
Press one of the buttons to
buttons select the component you want
to use. Press a pink-labeled
button after pressing SHIFT
(wk). When you press any of the
input buttons, the receiver turns
on. The buttons are factory
assigned to control Sony
components (page 51). You can
program the remote to control
non-Sony components
following the steps in
"Programming the remote"
(page 124).
D ZONE 2
Press to enable the zone 2
operation (page 106).
E TEST TONE Press to output the test tone
from each speaker.
F AMP
Press to enable the receiver
operation (page 39).
G MUSIC
Press to select sound field
(page 65).
H MOVIE
Press to select sound field
(page 65).
continued
11
GB