Batavus XF3 Mode D'emploi page 9

• Do not attempt any servicing or
adjustments other than those described
in this guide. Everything else must be left
to someone familiar with the maintenance
of electromechanical equipment and
authorized under the laws of the country
in question to carry out maintenance and
repair work.
• This product must be grounded. If
it should malfunction or breakdown,
grounding provides a path of least
resistance for electric current to reduce
the risk of electric shock. This product
is equipped with a cord having an
equipment-grounding conductor and a
grounding plug. The plug must be plugged
into an appropriate outlet that is properly
installed and grounded in accordance with
all local codes and ordinances.
DANGER:
Improper connection of the equipment-
grounding conductor can result in a risk
of electric shock. Check with a qualified
electrician or serviceman if you are in
doubt as to whether the product is
properly grounded. Do not modify the plug
provided with the product - if it will not fit
the outlet, have a proper outlet installed by
a qualified electrician.
NOTE ABOUT SAFETY FOR
UNITS WITH ELECTRICAL
pOWER
Before connecting the equipment to a
power source, make sure that the local
voltage matches that indicated on the type
plate: the equipment operates at either 230
v or 115 v (north american version). Note!
The equipment must be connected to a
grounded wall socket. Do not use extension
wires when connecting the equipment to
the power source. Always switch off the
power and unplug the equipment from the
electrical outlet immediately after using!
To reduce the risk of burns, fire, electric
shock or injury to persons:
1. The equipment should never be left
unattended when plugged in. Unplug the
equipment from the outlet when not in
use, before carrying out any maintenance
XF3_5_LOCKED.indd 9
O W N E R ' S M A N U A L
or repair procedures, and before moving
the unit.
2. Do not operate the equipment
under a blanket or other combustive
material. Excessive heating can occur
and cause fire, electric shock or injury to
persons.
3. Do not connect the equipment to
a power source, or operate the equipment
if there is any sort of damage to the power
cord or the unit itself.
4. Do not connect the equipment to
a power source or operate the equipment
outdoors or in damp locations.
5. Keep the power cord away from hot
objects.
6. Do not route the power cord
beneath a carper or place any objects
on the cord. Also make sure that the
power cord does not run underneath the
equipment.
7. Do not alter (for example lengthen)
the cord between the transformer and the
unit.
NOTE ABOUT ASSEMBLING
THE EQUIpMENT
Start by unpacking the equipment. The
detailed assembly instructions can be
found at the back of this guide. Follow the
instructions in given order.
Before assembly, check the contents of the
package. If a part is missing, please contact
your dealer with the model, equipment
serial no. and spare part no. of the missing
part. You'll find a spare part list at the back
of this guide. The hardware kit contents
are marked with * in the spare parts list.
The directions left, right, front and back
are defined as seen from the exercising
position. Keep the assembly tools, as you
may need them e.g. for adjusting the
equipment. Note that two people are
needed for the assembly.
The packaging includes a silicate bag for
absorbing moisture during storage and
transportation. please dispose of the bag
once you have unpacked the equipment.
Allow at least 100 cm of clearance around
G B
•
X F 3
9
14.7.2008 13:55:22