Bosch KSV Serie Mode D'emploi page 26

en
Fault
Temperature differs
greatly from the set
value.
Displays do not
illuminate.
Bottom
of the refrigerator
compartment is wet.
The temperature in
the refrigerator
compartment is too
cold.
The refrigerating unit
is switching on more
frequently and for
longer.
Appliance is not
cooling, temperature
display and light
are lit.
26
Possible cause
Power failure; the fuse
has been switched off;
the mains plug
has not been inserted
properly.
The condensation
channel or drainage
hole are blocked.
Temperature has been
set too low.
Appliance opened
frequently.
The ventilation
openings have been
covered.
Showroom mode is
switched on.
Remedial action
In some cases it is adequate to
switch off the appliance for
5 minutes.
If the temperature is too high wait a
few hours and check whether the
temperature has approached the set
value.
If the temperature is too low check
the temperature again the next day.
Connect mains plug. Check whether
the power is on, check the fuses.
Clean the condensation channel
and the drainage hole. See chapter
Cleaning the appliance. Fig. *
Increase the temperature.
Do not open the appliance
unnecessarily.
Remove obstacles.
Hold down temperature selection
button fig. 2/4 for 10 seconds until
an acknowledgement signal sounds.
After a short time check whether
your appliance is cooling.