General Operation - Velleman VTSSD5 Mode D'emploi

4. Overview
Refer to the illustrations on page 2 of this manual.
1
2
3
4
5. Installation
1. Before the first use, remove the four screws in the base plate that protect the
pump during transportation.
2. Install the appliance on a flat, stable and fire-resistant surface.
3. Screw the holder onto the station. You can fit the holder on the left or the right
side.
4. Make sure that the power switch is in the off position (0).
5. Plug the power cord into a suitable, earthed mains outlet.
6. Operation
6.1

General Operation

1. To switch on the appliance, set the power switch in the on position (I). The switch
lights up. The device starts heating up, the temperature and airflow values will be
displayed.
2. Set the temperature and airflow value with the respective
3. After setting, wait for the values to stabilize before starting to solder.
Please refer to chapter How to Solder below for handy tips.
Do not apply the soldering iron to the same place for a long time.
Do not leave the device unattended when switched on.
V. 01 – 16/03/2018
on-off switch
temperature setting
temperature display
airflow display
VTSSD5
5
6
7
5
holder
airflow setting
setting button
and buttons.
©Velleman nv