Optional Accessories - DeWalt DWV012 Guide D'utilisation

WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the motor.
Storage (Fig. 12)
1. Empty the canister, refer to To Empty Canister under
Operation.
2. Clean the vacuum inside and outside.
3. Clean or replace filters,
refer to Filters.
4. Store the suction hose and
the power cord as shown
in the illustration. Place
the unit in a dry room and
secure it from unauthorized
use.
NOTE: Plug inlet plug
(S) into inlet (J) to keep
debris inside canister when
suction hose is removed.
You can also attach the
ends of the hose together
and lock together with the
twist-lock end.
Accessories
WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce the risk
of injury, only D WALT recommended accessories should be used
E
with this product.
FIG. 12
S
J
8
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service center.
If you need assistance in locating any accessory, please contact
D WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
E
21286, call 1-800-4-D WALT (1-800-433-9258) or visit our website
E
www.dewalt.com.

OPTIONAL ACCESSORIES

HEPA filter: Captures 99.97% of all
particles greater than or equal to
DWV9320
0.3 microns. Required when picking up
lead paint debris.
5"–6" (127–152 mm)
DWE46100
Cutting/tuckpointing shroud
5" (127 mm) Cutting/tuckpointing
DWE46150
shroud
DWH050K DWH050 drilling dust extraction system
DWH052 demolition dust extraction
DWH052K
system