Preparation; Actions To Be Taken To Save Energy; First Use - Beko RDSE510M21S Manuel D'utilisation

4

Preparation

4.1. Actions to be taken
to save energy
A
Connecting the product to electronic
energy-saving system is inconvenient as
this may damage the product.
• Do not leave the doors of the product open for
a long time.
• Do not put hot food or drinks in the product.
• Do not overfill the product. When the inlet air
circulation is reduced, its cooling capacity is
prevented.
• Put your food in the product in closed
containers.
• You can store maximum amount of food items
in the freezer compartment of the product
when you remove the shelf of the freezer.
Energy consumption value stated for the
product has been determined by removing
freezer shelf and under maximum food load.
There is no harm to use a shelf according to
the shapes and size of food to be frozen.
• Defrosting the frozen food in fridge
compartment will both provide energy saving
and preserve the food quality.
• This device is designed to operate at ambient
temperatures up to 43°C (90 °F). It is equipped
with Advanced Electronic Temperature Control
System allowing to keep the frozen food in the
freezer defrost even the ambient temperature
reduces to -15 °C. When first installed the
product MUST NOT be placed in low ambient
temperatures.
• The baskets/drawers that are provided with the
chill compartment must always be in use for
low energy consumption and for better storage
conditions.
• Food contact with the temperature sensor in
the freezer compartment may increase energy
consumption of the appliance. Thus any
contact with the sensor(s) must be avoided.
Refrigerator / User Manual
• Do not contact the foods to the fridge
compartment temperature sensor indicated in
the figure below.

4.2. First use

Before you start using your refrigerator, make
sure that preparations are made according to
the instructions in the "Safety and environmental
instructions" and "Installation" sections.
• Run the product empty without putting food
for 6 hours and do not open the door unless
necessary.
C
You will hear a sound when the
compressor starts. The liquids and gases
compressed within the cooling system may
produce sound even if the compressor is
not running and that sound is normal.
C
The front edges of the product may be hot.
This is normal. These areas are designed
to be heated to prevent condensation.
11/18 EN