Faber INCA LUX Série Instructions D'installation page 8

BEFORE FITTING THE HOOD TO THE WALL UNIT, PROCEED AS FOLLOWS:
INSTALLATION
The Hood can be installed directly on the underside of the wall unit
(Minimum 24" - 30" from the Cooking Surface).
Create an opening in the bottom of the wall unit, as shown.
nectors.
• Disconnect the wires to the Commands at the connectors.
• Disconnect the wires to the Light at the con-
nectors.
underside of the wall unit (Minimum 650 mm
from the Cooker Hob).
• The Hood can be installed directly on the
underside of the wall unit (Minimum 650 mm
as shown.
from the Cooker Hob).
• Create an opening in the bottom of the wall unit,
as shown.
place.
• Insert the hood until the side supports snap into
place.
Vf
• Fasten using the 10 screws 12a provided.
underneath the hood.
• Lock in position by tightening the screws Vf from
underneath the hood.
Open the filter cover panel by turning the specific knob.
Disconnect the panel from the hood canopy by sliding the fixing • Open the suction panel by turning the specific knob.
• Disconnect the panel from the hood canopy by sliding the
pin levers.
fixing pin lever.
fixing pin lever.
• Remove grease filters.
Remove grease filters
and set aside.
• Screw the Frame into place
using the 6 screws 12f, re-
using the 6 screws 12f, re-
connect the wires to the
connect the wires to the
Commands and Light, re-
place the metal grease filter
Commands and Light, re-
and the Panel.
place the metal grease filter
Screw the Frame into place using the 6 screws
and the Panel.
12f(1/8"x5/16" torx), reconnect the wires to the
Connector and the Electrical ground cable (Yellow/
Green) removed previously. Replace the metal grease
filter and the Panel.
EN
EN
8
INSTALLATION
BEFORE FITTING THE HOOD TO THE WALL UNIT, PROCEED A
Fitting the Hood canopy
• Disconnect the wires to the Commands at the connectors.
BEFORE FITTING THE HOOD TO THE WALL UNIT, PROCEED AS FOLLOWS:
• Disconnect the wires to the Light at the con-
nectors.
• The Hood can be installed directly on the
underside of the wall unit (Minimum 650 mm
from the Cooker Hob).
• Create an opening in the bottom of the wall unit,
as shown.
• Insert the hood until the side supports snap into
Insert the hood until the side supports snap into place.
place.
Fasten using the 10 screws 12a provided.
Lock in position by tightening the screws Vf from underneath the hood.
• Fasten using the 10 screws 12a provided.
• Lock in position by tightening the screws Vf from
underneath the hood.
• Open the suction panel by turning the specific knob.
• Disconnect the panel from the hood canopy by sliding the
fixing pin lever.
• Remove grease filters.
• Screw the Frame into place
using the 6 screws 12f, re-
connect the wires to the
Commands and Light, re-
7 7
place the metal grease filter
and the Panel.
Fitting the Hood canopy
Fitting the Hood canopy
7 7
7 7
7