Assembling The Stand - Ryobi RTS12T Manuel D'utilisation

ASSEMBLING THE STAND

See Figures 7 - 8.
NOTE: Do not use this leg stand with other equipment or
for other purposes.
 Rest the inner leg assembly inside of the outer leg
assembly, so that the legs form an "X". Align holes for
hardware.
 Install leg stand bolts through holes and secure with hex
nuts. Tighten nuts securely.
 Insert feet into the leg assemblies. Align holes for hardware.
NOTE: The feet should point away from the assembly as
shown in figure 8.
 Install foot bolts through holes and secure with hex nuts.
Tighten nuts securely.
MOUNTING THE TABLE SAW TO THE LEG
STAND
See Figures 9 - 10.
WARNING:
Do not lift the saw without help. The saw weighs
approximately 55 lbs. Hold it close to your body. Keep
your knees bent and lift with your legs, not your back.
Ignoring these precautions can result in back injury.
 With the unit in the upright position, spread the legs of
the stand. Place stand on level ground.
NOTE: When positioning the stand make sure each leg
is spread fully outward to ensure the stand's stability.
OUTER LEG
ASSEMBLY
LEG
STAND
BOLT
ASSEMBLY
INSIDE LEG
ASSEMBLY
HEX
NUT
Fig. 7
FOOT
BOLT
16 - English
HEX
NUT
Fig. 8
Fig. 9