Ryobi RTS23 Manuel D'utilisation page 18

INSTALLING THE SLIDING TABLE EXTENSION
See Figures 13 - 14.
Locate the following parts:
Sliding Table Extension ............................................... 1
Stop Screw ................................................................. 1
Screw (M4 x 25 mm, Truss Hd.) .................................. 1
Indicator ...................................................................... 1
Rip Indicator End Cap ................................................ 1
Handle End Cap.......................................................... 1
To install sliding table extension:
 Unlock the front and back table locking levers on the
sliding table extension.
 Insert sliding table extension into table locking levers.
 Push the sliding table extension until it rests against the
saw table and is completely closed.
 Install the stop screw into hole on the bottom of the rear
extension rod to hold sliding table extension into locking
levers.
 Lock the front and back table locking levers.
To install indicator:
 Press the end cap over the front extension rod (see
figure 14).
 Slip the indicator thru the slot in the front rail of the table
and into the rip indicator end cap.
 Fit the top slot in the indicator over the detent on the end
plug and the bottom slot over the screw hole on the end
cap.
STOP
TABLE
SCREW
LOCKING
LEVER
SLIDING TABLE
EXTENSION
REAR
EXTENSION ROD
ASSEMBLY
 Insert a screw into the bottom slot of the indicator, the
hole in the end cap and the extension rod.
 Align the indicator to the 17 in. mark.Tighten securely, but
do not overtighten. Overtightening may crush extension
rod ends.
EXTENSION
ROD
17 in.
MARK
Fig. 13
18 - English
RIP INDICATOR
END CAP
DETENT
INDICATOR
INDICATOR
SCREW
Fig. 14