Functional Description - Milwaukee 3632-20 Manuel De L'utilisateur

SPECIFICATIONS
Cat. No. ..................................................... 3632-20
Volts.............................................................. 12 DC
Battery Type .................................................M12™
Charger Type................................................M12™
Laser............................................................Class 2
Max Power........................................... P
Frequency....................................................10 KHz
Pulse Duration Normal Mode ................. T
Pulse Duration Power Save.................... T
Wavelength.......................................... 510-530 nm
Beam Divergence ........................................... 3 rad
Storage Temp .................................... -4°F to 120°F
Working Range .................................................125'
Range with Detector .........................................165'
Accuracy ...............................................±1/8" @ 33'
Settle Time ......................................... < 3 Seconds
Tripod Mount ..................................1/4"-20, 5/8"-11
Ingress Protection............................................ IP54
Drop Rating .......................................................1 m
Leveling ............Auto ±°4 side to side, front to back
Recommended Ambient
Operating Temperature .................. 14°F to 104°F

FUNCTIONAL DESCRIPTION

1. Laser apertures
2. On/Off dial
3. Pivot Bracket
4. Micro adjust
5. Fuel gauge
1
1
1
7
6
5
4
10
9
≤ 8 mW
AVG
≤ 80 µs
p
≤ 50 µs
p
6. Plane selector buttons
7. Power on indicator
8. Threaded inserts
9. Magnets
10. Nail/Screw hole
8
WARNING
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
may be hazardous.
Use power save mode to extend the battery run
time. Power save mode is indicated by dimmed
laser beams and the Power ON indicator pulsing.
Visual range is decreased in power save mode. To
2
turn power save mode ON or OFF, press and hold
any plane selector button for 3 seconds. The tool will
automatically switch to power save mode if less than
3
7% of battery charge remains.
To determine the amount of charge left in the battery,
turn the tool ON.
LEDs
4 LEDs
3 LEDs
2 LEDs
1 LED
1 LED flashing 0-7% Battery charge
1 LED flashes
4 times & tool
will not run
4 LEDs flash
alternately
3
SYMBOLOGY
Volts
Direct Current
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
Magnets
Read operator's manual
ASSEMBLY
Recharge only with the charger
specified for the battery. For spe-
Always remove battery pack before
changing or removing accessories.
Only use accessories specifically
recommended for this tool. Others
Power Save
Fuel Gauge
Description
66-100% Battery charge
45-65% Battery charge
18-44% Battery charge
8-17% Battery charge
Power Save Mode enabled.*
End of charge.
Charge the battery pack.
System error. Tool shuts off.
Contact a MILWAUKEE service
facility.