Getting Started; Setting Up; Wall Mounting - Hama 00095290 Mode D'emploi

5. Getting Started

5.1 Setting up

• Screw the foot into the threaded hole on the back of the device.
• Remove the protection foil from the display.
• Set the product on a flat, level surface where it will not slip.
• Do not place any other objects on top of the device.

5.2 Wall mounting

Alternatively, you may use the threaded hole on the back of the device to mount it to the wall
using a VESA-compatible wall bracket.
VESA specification in the corresponding technical data.
Note on available accessories
You can find a selection of compatible Hama products at www.hama.com.
Note
• Before mounting, check that the wall you have chosen is suitable for the weight to be
mounted Also make sure that there are no electric, water, gas or other lines running
through the wall at the mounting site.
• Buy special or suitable installation material from a specialised dealer for wall-mounting.
• Do not mount the product above locations where persons might linger.
GB
8