Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Remove the cover from the field wiring compartment. (SEE
FIGURE 11) DO NOT turn on the power until installation is
23
complete! Connect the Power Supply Cable to the rangehood.
9
Connect the Green (Green and Yellow) ground wire under the
Green grounding screw. Attach the White lead of the power
supply to the White lead of the rangehood with a twist-on type
7.1a
wire connector. Attach the Black lead of the power supply
to the Black lead of the rangehood with a twist-on type wire
connector.
7.1b
2.1
A. Home power supply cable
B. Black wires
C. UL listed wire connectors
A. Cable de la fuente de alimentación doméstica
2.2
D.White wires
B. Cables negros
E. Green (or bare) ground wire from home power supply
C. Conectores de cable con homologación UL
connected to green ground screw
D. Cables blancos
F. Range hood power supply cable
E. Cable de tierra verde (o decubierto) de la fuente de alimentación doméstica conectado
G.Range hood power supply cable connected to green
a un tornillo de tierra verde
ground screw
F. Cable de alimentación de la campana extractora
G. Cable de alimentación de la campana extractora conectado al tornillo de tierra verde
10
Ductless installations require
a Ductless Conversion
Kit whose components are
12f
pictured in FIGURE 12. Do
not use the DAMPER (M
in FIGURE 1) for ductless
installations. The LOWER
C H I M N E Y C O V E R ( B
in FIGURE 1) should be
discarded and replaced by
the new one with holes from
the Ductless Conversion Kit
(D in FIGURE 12).
As indicated in FIGURE
12, place the DUCTLESS
11
12h
9.1
9
25
12e
24
FIGURE 11
12c
FOR DUCTLESS INSTALLATIONS
Coloque la parte superior de la chimenea y fije la parte
superior al bastidor con los 2 tornillos que se han quitado
anteriormente.
1. The UPPER CHIMN
COVER (C in FIGURE
Instalación de la
attaches to the top of
conexión de cableado
support structure using
Retire la tapa del compartimento
screws provided (G in FIGU
de cableado de campo.
13). If using the High Cei
NO encienda la unidad hasta que
Chimney Kit, use the UPP
se haya completado la instalación.
CHIMNEY COVER supp
Conecte el cable de la fuente de
with the kit. Slide up
alimentación a la campana.
attach the UPPER CHIMN
Conecte el cable de tierra verde
COVER.
(verde y amarillo) debajo del
tornillo de conexión a tierra verde.
2. Attach the duct work to
Conecte el cable blanco de la
DAMPER (M in FIGURE
fuente de alimentación al cable
Make sure to seal all joints
blanco de la campana con un
duct tape to prevent leaks
conector de cable tipo twist-on.
Conecte el cable negro de la
3. The LOWER CHIMN
fuente de alimentación al cable
COVER (B in FIGURE
negro de la campana con un
attaches using two scr
conector de cable tipo twist-on.
provided (G in FIGURE
Install the LOWER CHIMN
Reemplace la cubierta del
COVER by sliding it up o
compartimiento de cableado de
the support and the UPP
campo y los filtros de grasa.
CHIMNEY COVER.
For ductless installations
EXTENSIONS HORIZON
in the LOWER CHIMNEY
in the VENT GRIDS (C i
50
Publicité
Table des Matières
