Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Remove the cover from the field wiring compartment. (SEE
23
FIGURE 11) DO NOT turn on the power until installation is
8
complete! Connect the Power Supply Cable to the rangehood.
Connect the Green (Green and Yellow) ground wire under the
Green grounding screw. Attach the White lead of the power
supply to the White lead of the rangehood with a twist-on type
7.1a
wire connector. Attach the Black lead of the power supply
to the Black lead of the rangehood with a twist-on type wire
connector.
7.1b
2.1
A. Home power supply cable
B. Black wires
A. Home power supply cable
C. UL listed wire connectors
B. Black wires
D.White wires
2.2
C. UL listed wire connectors
E. Green (or bare) ground wire from home power supply
D. White wires
connected to green ground screw
E. Green (or bare) ground wire from home power supply
F. Range hood power supply cable
connected to green ground screw
G.Range hood power supply cable connected to green
F. Range hood power supply cable
ground screw
G. Range hood power supply cable connected to green
ground screw
9
Ductless installations require
a Ductless Conversion
Kit whose components are
pictured in FIGURE 12. Do
12f
not use the DAMPER (M
in FIGURE 1) for ductless
installations. The LOWER
C H I M N E Y C O V E R ( B
in FIGURE 1) should be
discarded and replaced by
the new one with holes from
the Ductless Conversion Kit
(D in FIGURE 12).
As indicated in FIGURE
Position the upper chimney section and fix the upper part to the frame using the 2 screws removed previously.
12, place the DUCTLESS
DIVERTER (A) over the
exhaust opening of the EASY
MAKE THE ELECTRICAL CONNECTION
11
12h
9.1
9
25
12e
24
FIGURE 11
12c
FOR DUCTLESS INSTALLATIONS
Attachment of Upper and Lower Flues
1. The UPPER CHIMNEY
COVER (C in FIGURE 13
Installation of wiring
attaches to the top of th
connection
support structure using tw
Remove the cover from the
screws provided (G in FIGURE
field wiring compartment.
13). If using the High Ceilin
DO NOT turn on the power until
Chimney Kit, use the UPPER
installation is complete!
CHIMNEY COVER supplie
Connect the Power Supply
with the kit. Slide up an
Cable to the rangehood.
attach the UPPER CHIMNEY
Connect the Green (Green and
COVER.
Yellow) ground wire under the
Green grounding screw. Attach
2. Attach the duct work to th
the White lead of the power
DAMPER (M in FIGURE 1
supply to the White lead of the
Make sure to seal all joints wit
rangehood with a twist-on type
duct tape to prevent leaks.
wire connector.
Attach the Black lead of the
3. The LOWER CHIMNEY
power supply to the Black lead
COVER (B in FIGURE 13
of the rangehood with a twist-
attaches using two screw
on type wire connector.
provided (G in FIGURE 13
Install the LOWER CHIMNEY
Replace the field wiring compart-
COVER by sliding it up ove
the support and the UPPER
ment cover and the grease filters.
CHIMNEY COVER.
For ductless installations, lin
EXTENSIONS HORIZONTA
in the LOWER CHIMNEY CO
in the VENT GRIDS (C in F
INSTALLING
12
Publicité
Table des Matières
