Before You Start; Features; What's In The Box; Inserting The Battery - Pioneer A-A6-J Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16

Before you start

Chapter 1:
Before you start

Features

Quick response power supply circuit
The superior power supply circuit adopted by
this unit achieves vastly improved response by
employing 'no feedback' circuitry and low
impedence parallel main capacitors character-
isticly used in professional audio monitoring.
Twin-mono symmetrical construction
This amplifier offers a new advancement in
stereo imaging with the completely
independent construction of left/right power
amplification units and twin transformers.
Direct construction
In addition to the improved symmetrical
design, the signal path of each block is
designed for shortest signal path for minimum
deterioration of signal clarity.
Wide-Range Linear Circuit
Through this proprietary feedback circuit, an
output signal of low impedance offering a flat,
even response over the widest possible
frequency range is delivered to your speakers.
Fine-tuned to world-class standards
With the cooperation of the world-class studio
engineers at AIR Studios, this amplifier has
been AIR Studios certified:

What's in the box

Please confirm that the following accessories
are in the box when you open it.
• Remote control
(CR2025)
Lithium battery
• Power cable
• Operating instructions
• Warranty card

Inserting the battery

Insert the lithium battery (CR2025) into the
remote control as shown below. The battery
supplied with this unit is stored in the battery
casing (see step 3 below). When you notice a
decrease in the operating range, replace the
battery in the same manner.
2
1
1
Push the release tab to the right to
open the battery casing.
2
Pull out the battery casing.
3
Remove the battery from the casing.
If you're doing this for the first time, remove the
protective seal from the battery supplied with
the system before re-inserting it.
4
Place a new battery in the casing.
Make sure the  side of the battery is facing up
when you place it in the space provided.
4
3
01
5
En

Publicité

Table des Matières
loading

Table des Matières