Sony SCD-X501ES Mode D'emploi page 20

6
Turn . AMS > until the desired
item appears on the display.
Select the item from "SURR BAL",
"CNTR BAL", or "SW BAL".
Note
When you set the playback mode so that the sub
woofer is set to "––" in the Multi-channel mode
(page 18), "SW BAL" cannot be adjusted ("NOT
IN USE" appears). Similarly, "CNTR BAL" or
"SURR BAL" cannot be adjusted ("NOT IN
USE" appears) when you set the playback mode
so that the corresponding speaker is set to "––."
7
Press . AMS >.
The balance adjustment display appears.
In stop mode, the test tone is output from
the selected speaker.
Example:
When you select "SURR BAL" during stop
mode, the test tone is output from the front
speakers and surround speakers.
8
Turn . AMS > to adjust the output
level.
Note
The output level balance can be adjusted in up to
24 steps. Since fine adjustments can be made, it
may be difficult to observe the movement of
needle.
9
Press . AMS >.
The player status returns to Step 6.
Repeat Steps 6 through 9 for more
adjustments.
10
Press MENU after you finish adjusting.
The display returns to the normal display.
To adjust the output level from
the remote
You can adjust the output level of each speaker
from the listening position by using the supplied
remote.
1
Press LEVEL ADJ during playback or
stop mode.
GB
20
During playback, go to Step 4.
2
Press ./> repeatedly until "TONE
ON" appears on the display.
3
Press ENTER.
The test tone issues from the speakers in
sequence with the speaker type appearing
on the display.
4
Press ./> repeatedly until the
desired item appears on the display.
Select the item from "SURR BAL",
"CNTR BAL", or "SW BAL".
Note
When you set the playback mode so that the sub
woofer is set to "––" in the Multi-channel mode
(page 18), "SW BAL" cannot be adjusted ("NOT
IN USE" appears). Similarly, "CNTR BAL" or
"SURR BAL" cannot be adjusted ("NOT IN
USE" appears) when you set the playback mode
so that the corresponding speaker is set to "––."
5
Press ENTER.
The balance adjustment display appears.
In stop mode, the test tone is output from
the selected speaker.
Example:
When you select "SURR BAL" during stop
mode, the test tone is output from the front
speakers and surround speakers.
6
Press ./> repeatedly to adjust
the output level.
Note
The output level balance can be adjusted in up to
24 steps. Since fine adjustments can be made, it
may be difficult to observe the movement of
needle.
7
Press ENTER.
The player status returns to Step 4.
Repeat Steps 4 through 7 for more
adjustments.
8
Press LEVEL ADJ after you finish
adjusting.
The display returns to the normal display.