Maintenance And Cleaning; Environmental Protection; Declaration Of Conformity - Bosch PST 650 PE Instructions D'emploi

Maintenance and Cleaning

Before any work on the machine itself, pull the
I
mains plug.
For safe and efficient working, always keep the ma-
I
chine and the ventilation slots clean.
To avoid malfunctions, do not work with materials that
produce large amounts of dust from below or over-
head. Clean the saw blade holder regularly, for exam-
ple, by lightly tapping the machine on a flat surface.
In extreme working conditions, conductive dust
I
can accumulate in the interior of the machine when
working with metal. The protective insulation of the
machine can be degraded. The use of a stationary
extraction system is recommended in such cases
as well as the frequent blowing out of the ventilation
slots and the installation of a residual current circuit
breaker (RCD).
Lubricate the guide roller 10 from time to time with a
drop of oil and check for wear. If it is worn, it must be
replaced.
WARNING
Important instructions for connecting a new 3-
pin plug to the 2-wire cable.
The wires in the cable are coloured according to the
following code:
Strain relief
Live = brown
Neutral = blue
Do not connect the blue or brown wire to the earth ter-
minal of the plug.
Important: If the plug on the cable of this machine
must be replaced, dispose of the old plug to prevent
misuse.
If the machine should fail despite the care taken in
manufacture and testing, repair should be carried out
by an authorised customer services agent for Bosch
power tools.
For all correspondence and spare parts orders, always
include the 10-digit order number of the machine.
2 609 932 299 • (03.03) T

Environmental Protection

Recycle raw materials instead of disposing as
waste.
The machine, accessories and packaging should be
submitted for environment-friendly recycling.
These instructions are printed on recycled paper man-
ufactured without chlorine.
The plastic components are labelled for categorised
recycling.
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents:
EN 50 144 according to the provisions of the direc-
tives 89/336/EEC, 98/37/EC.
Dr. Egbert Schneider
Senior Vice President
Engineering
To be fitted
by qualified
professionals only
Robert Bosch GmbH, Geschäftsbereich Elektrowerkzeuge
Specification subject to alteration without notice
English–5

Declaration of Conformity

Dr. Eckerhard Strötgen
Head of Product
Certification