Troubleshooting Guide - Cavavin V-024WDZ Manuel D'instruction

1. Place the cabinet on open operation place, the door opened to the maximum angle
2. Use small knife (2) to take off the decorative nail (1) on opposite side (Drawing 1);
3. Use the inner six angle screwdriver (Tool 5) to disassemble the screws (4) of drop-proof device (3), then
remove the drop-proof device. (Drawing 1)
4. Hold the door, use six angle screwdriver (Tool 5) to screw out the door shaft core(6) from the two ends of the
top of the door. Take out the door and set aside. (Drawing 2)
5. Discharge the upper and lower door hinge (7)(8) with M5 inner six angle screwdriver (Tool 5), then assemble
the door hinge on the opposite side. (Drawings 3 and 4)
6. Rotate the door 180 degrees, then install the door on the opposite side of the cabinet. (Drawing 5)
7. Finally, install the decorative nail and drop-proof device at the opposite side. (Drawing 6)
Fan
To clean the fan of the cellar, remove the kickplate using a screwdriver to loosen the two screws and clean the dust that
can be accumulated. It is very important to do this at least once a year.
You can solve many common wine cellar problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM

TROUBLESHOOTING GUIDE

1.Decorative nail
2. Knife
3. Drop-proof device
4. M5 six angle screw
5. M5 six angle screwdriver
6. Inner six angle door spindle
core
7. Upper door hinge
8. Lower door hinge
CAUSE POSSIBLE
45