Description Of The Unit; Operation; Handling - Daikin LBS Série Manuel D'installation Et D'utilisation

3

Description of the unit

1
LBS (Outdoor Unit)
4

Operation

5

Handling

WARNING
Make sure that no one is in transit in the operating area of the lifting/transport means to
prevent any possible accidents to people.
If the unit is in a wooden case or crate, sling the packing properly before handling it.
Lifting speed shall be such as not to make the packed unit oscillate dangerously and possibly
fall.
The LBS-LBT series includes air-cooled or water-cooled (optional) condensing units built
in split version. They consist of:
1. a condensing unit placed outside the cold room;
2. an evaporator installed inside the cold room;
3. an electric control panel placed on the condensing unit, complete with wall-
mounted remote control panel;
4. two tubes (pre-charged with refrigerant) to be connected to the corresponding
fittings placed on the evaporating and condensing units.
LBS-LBT single blocks are compression units where cold is produced by vaporizing a liquid
refrigerant (HFC type) at low pressure in a heat exchanger (evaporator). The resulting vapour
is brought again into the liquid state by mechanical compression at a higher pressure, followed
by cooling in another heat exchanger (condenser).
The compressor is hermetic, with reciprocating motion, supplied with single-phase or three-
phase power.
Defrost takes place automatically in pre-set cycles, by injecting hot gas ( standard); manual
defrost is also possible.
The unit can be handled by lifting and transport means.
LBT (Indoor Unit)
3
3
18