Bucking Spike; Fueling - Efco MT 4400 Manuel D'utilisation Et D'entretien

en
18
OPERATION

Bucking Spike

WARNING: Your chain saw is fitted with a bucking
spike (A, Fig. 34). The bucking spike is very sharp
and can cause injury. Be extremely careful when
working near the bucking spike.
34
WARNING: Removal of the bucking spike will violate
the saws compliance of SAE J335 and other standards.
See Safety-State and Local Requirements.

Fueling

(Do Not Smoke!) (Fig. 37)
This product is powered by a 2-cycle engine and requires pre-mixing
gasoline and 2-cycle oil. Pre-mix unleaded gasoline and 2-cycle
engine oil in a clean container approved for gasoline (Fig. 35).
RECOMMENDED FUEL: THIS ENGINE IS CERTIFIED TO
OPERATE ON UNLEADED GASOLINE INTENDED FOR
AUTOMOTIVE USE WITH AN OCTANE RATING OF 89 ([R + M] / 2)
OR HIGHER (Fig. 36).
35
Mix 2-Cycle Engine Oil with gasoline according to the instructions
on the package. We strongly recommend the use of 2% (1:50)
Efco Two Cycle Engine Oil, which is specifically formulated for all
Efco air-cooled two-stroke engines.
The correct oil / fuel proportions shown in the table below are
suitable when using the Efco Two Cycle Engine Oil or an
equivalent high-quality engine oil (JASO specification FD or ISO
specification L-EGD). When oil specifications are NOT equivalent
or unknown use 4% (1:25) oil / fuel mixing ratio.
CAUTION: DO NOT USE AUTOMOTIVE OIL OR
2-CYCLE OUTBOARD OIL.
36
CAUTION:
- Match your fuel purchases to your consumption;
don't buy more than you will use in one or two
months;
- Store gasoline in a tightly-closed container in a
cool, dry place.
CAUTION - For the mixture, never use a fuel with an
ethanol percentage higher than 10%; gasohol (mixture
of gasoline and ethanol) up to 10% ethanol or E10
fuel are acceptable.
When using an Oxygenated Gasoline a good practice of Fuel
Management is necessary.
37
Gasoline Oxygenated with alcohol readily takes/up water when it
is present; the water may be condensed out of humid air or be a
contaminant in the fuel system, including tank.
The use of Oxygenated Gasoline may cause the occurrence of
vapor-lock easier.
NOTE - Prepare only the quantity of mixture required for
immediate use; do not leave fuel in the tank or a container for a
long time. Were commend the use of the additive Emak ADDITIX
2000 code 001000972 if the mixture is to be stored for 30 days.
Alkylate gasoline
CAUTIONS – Alkylate fuels have different density
than normal fuel. Therefore engines, set with normal
fuel, need different H jet regulation to avoid critical
issues. For this operation it's necessary turned at a
Licensed Service Dealer.