Install The Hood (Standard Installation) - Venmar CHEF VCNDD1 Série Manuel D'installation

1 ] Run the house power cable between service panel and hood location. Run the house power
2 ] Hang hood from 4 mounting screws previously installed. Slide hood back towards the wall
18

Install the Hood (Standard Installation)

cable into the hood through the strain relief previously installed in step 6 on page 10.
until mounting screw heads are engaged in the narrow end of keyhole slots in top of hood.
While holding the hood, tighten screws securely. Attach power cable to the hood using the
strain relief.
3 ] Connect ductwork to hood and use metal foil duct tape to make joints secure and airtight.
Make sure the damper assembly (or round duct plate) enters the ductwork and that the
damper opens and closes freely.
DUCTED INSTALLATION ONLY