Venmar CHEF VCNDD1 Série Manuel D'installation page 10

5 ] Remove 2 screws from top of hood (see illustration below). Keep the screws for further use).
2 SCREWS
6 ] Remove the Electrical Power Cable Knockout from top (vertical exhaust) or back (horizontal
exhaust) of hood. Install an appropriate strain relief, 1/2" diameter (not included).
ELECTRICAL
POWER CABLE
KNOCKOUT
NON-DUCTED INSTALLATION ONLY
7 ] Remove the 3 screws retaining the recirculation cover plate (shaded part in illustration
below) to the hood. Discard this plate with its screws.
SCREWS
RECIRCULATION
COVER PLATE
10