Troubleshooting - Greencut GLM200L Manuel D'utilisation

TROUBLESHOOTING

The table includes some of the most common problems, their causes and remedies.
PROBLEM
The battery is not charged.
The switch is defective.
The mower does
Grass is stuck between the cover and the blade.
not start.
The battery is not fully inserted into the mower.
The battery may require service or replacement.
The grass is rough or uneven.
The mower cuts
the grass unevenly.
The cutting height is not set correctly.
Wet grass clippings are stuck to the underside
The mower
of the cover.
does not mulch
properly.
The blade is damaged.
The grass is too tall, or the cutting height is too
low.
The mower is
hard to push.
The back of the grass collection basket is
dragging on thick grass.
The motor shaft is bent.
The mower is
excessively noisy The blade is unbalanced.
and vibrates.
The screws/parts are loose.
NOTE: If you are unable to resolve the problem, please contact the Official Technical Service.
POSSIBLE CAUSE SOLUTION
Charge the battery.
Replace the switch
Remove the battery, check if there are any jams
under the cover.
Check the connection between the battery and
the mower. Make sure that the battery fits in
place.
Replace the battery.
Check the cutting area.
Move the handles to a higher setting
Wait until the grass is dry before mowing.
Sharpen the blade or replace it.
Raise the cutting height.
Empty the grass clippings from the grass
collection basket.
Stop the engine and inspect for damage.
Repair before restarting.
Tighten the screws.
55
EN