Fender FWG 2020 Mode D'emploi page 8

FCC STATEMENT
The transmitter has been tested and found to comply with the
limits for a low-power auxiliary station pursuant to Part 74 of the
FCC Rules. The receiver has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equip-
ment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiv-
er.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Shielded cables and I/O cords must be used for this equipment to
comply with the relevant FCC regulations. Changes or modifica-
tions not expressly approved in writing by FMIC may void the user's
authority to operate this equipment.
The receiver complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause unde-
sired operation.
USA only: FCC CONSUMER ALERT
Most users do not need a license to operate this wireless system.
Nevertheless, operating this system without a license is subject to
certain restrictions: the system may not cause harmful interference;
it must operate at a low power level (not in excess of 50 milliwatts);
and it has no protection from interference received from any other
device.
Purchasers should also be aware that the FCC is currently evaluating
use of wireless systems, and these rules are subject to change. For
more information, call the FCC at 1-888- CALL-FCC (TTY: 1-888-TELL-
FCC) or visit the FCC's website at www.fcc.gov/cgb/wirelessmicro-
phones.
1. GENERAL
Introduction
The FWG 2020 wireless system comprises a stationary diversity receiv-
er and the bodypack transmitter. The receiver and transmitter oper-
ates in a 30 MHz sub-band of each frequency set within the 500 MHz
to 865 MHz UHF band. You can select the receiving frequency from the
preprogrammed frequency groups and sub-channels of your receiver
or set it directly in 25 kHz-increments. The bodypack transmitter is set
to the parameters selected on the receiver via infrared transmission.
2
Accessories/Parts
Part Number Item
7704710000 PASSIVE DIRECTIONAL ANTENNA
7744711000 ACTIVE DIRECTIONAL ANTENNA
7704712000 PASSIVE WD-BND OMNIDIRECTIONAL ANTENNA
7704713000 ACTIVE WD-BND OMNIDIRECTIONAL ANTENNA
7704714000 POWER SW SUPPLY 12V 500 MA MULTIPLUG
7704715000 BODY PACK TRANSMITTER CHARGING STATION
7704716000 PT 2020 WIRELESS BODY PACK TRANSMITTER
7704717000 FMKPS ANTENNA CABLE 2 FT 65 CM
7704718000 FMKA5 ANTENNA CABLE 16 FT 5 M
7704719000 FMKA20 ANTENNA CABLE 66 FT 20 M
7704720000 FRONT MOUNT ANTENNA RACKMOUNT KIT
7704722000 ITC3 INSTRUMENT TRANSMITTER CABLE 3 FT
Receiver
Front Panel
i Refer to fig. 1 on page iii.
1 POWER: Switches power to the unit on or off.
2 LCD display: The receiver provides a back-lit LCD display.
The display indicates all receiver parameters:
a RF bar-graph indicating the field strength of the received
signal
b Alphanumeric display of the current setting
c Parameter to be adjusted, mode
d Audio bar-graph indicating the received audio level
e LOCK symbol
f Available channels (for automatic frequency setup)
•
If one or more warning functions are activated, the display will be
back-lit in red when a critical condition occurs. As long as all param-
eters are within their normal ranges, the display is back-lit in green.
3 t l u : These three keys set the various parameters of the receiver.
• In LOCK mode:
Short push on t or u : scrolls through the Frequency, Preset,
and receiver Name screens.
Long push on l : selects SETUP mode.
• In SETUP mode only: