Setup"/"Gen .Serv ." Menu; Device"/"Rs232" Menu - Sartorius Entris II BCE Série Mode D'emploi

System Settings
Parameter Setting values
ISOCAL OFF
NOTE
ON*
EXT .CAL . UNLCKED*
LOCKED
* Factory setting
7 .3 .2

"SETUP"/"GEN .SERV ." Menu

Parameter Setting values
MENU .RES . DEFAULT
NO*
* Factory setting
7 .3 .3

"DEVICE"/"RS232" Menu

Parameter Setting values
DAT .REC . XBPI
SBI*
REM .DISP .
BARCODE
YDP20
YDP30
OFF
BAUD 600, 1200, 2400,
4800, 9600*,
19200, 38400,
57600, 115200
PARITY ODD*
EVEN
NONE
HANDSHK . SFTWARE
HRDWARE*
NONE
* Factory setting
20 Entris BCE Operating Instructions
®
Explanation
Switches the isoCAL function off .
If the balance needs to be calibrated: The [isoCAL] button flashes . The isoCAL
function must be manually triggered with the [Adjust] button .
Activates the isoCAL function . The device is automatically adjusted as soon as a
trigger starts the isoCAL function .
Activates the external calibration/adjustment function under [CAL ./ADJ .] .
Deactivates the external calibration/adjustment function under [CAL ./ADJ .] .
Explanation
Resets the system settings to the factory default settings .
Deactivates the option of resetting the device menu .
Explanations
Extended range of commands to control numerous balance functions with
binary protocol for direct communication with the device .
Enables SBI communication . The data is output to a PC or control unit . Enables
the use of ESC commands from a PC to control the basic balance functions with
ASCII protocol .
Enables data output on another display .
Allows for the connection of an approved barcode scanner .
Sets the standard settings of YDP20 printers .
Sets the standard settings of YDP30 printers .
Deactivates the automatic data output .
Sets the baud rate to the selected value .
Applies an odd parity .
Applies an even parity .
Does not apply a parity .
Sets the handshake protocol to software handshake .
Sets the handshake protocol to hardware handshake .
Does not set a handshake protocol .