Troubleshooting - JVC KD-X50BT Manuel D'instructions

Troubleshooting

Symptom
General
No sound, sound interrupted or
static noise.
"MISWIRING CHK WIRING THEN
RESET UNIT"/"WARNING CHK
WIRING THEN RESET UNIT"
appears on the display and no
operations can be done.
The unit does not work at all.
Source cannot be selected.
The correct characters are not
displayed (e.g. album name).
FM/AM
SSM automatic presetting does
not work.
USB/iPod/iPhone
"READING" keeps flashing on the
display.
Tracks/folders are not played
back in the order you have
intended.
"NO FILE" appears on the display.
"NOT SUPPORT" appears on the
display and track skips.
"CANNOT PLAY" flashes on
the display.
The unit cannot detect the
connected device.
The iPod/iPhone does not turn
on or does not work.
"CANNOT SKIP"
"NO STATION"
"NO ACTIVE STATION"
"SET UP PANDORA ON YOUR
DEVICE"
New station creation:
"NO STATION"
"STATION REACH LIMIT"
"CANNOT MAKE NEW
STATION"
Check the cords, antenna and cable connections.
Check the condition of the connected device and recorded
tracks.
Ensure to use the recommended stereo mini plug when
connecting to an external component. (
Ensure the terminals of the speaker leads are properly insulated
with tape before resetting the unit. (
If the message does not disappear, consult your JVC car audio
dealer or kits supplying company.
Reset the unit. ( page 3)
Check the <SRC SELECT> setting. (
This unit can only display letters (upper case), numbers, and a
limited number of symbols.
Store stations manually.
A longer readout time is required. Do not use too many
hierarchical levels and folders.
Reattach the USB device.
The playback order is determined by the file name.
Check whether the selected folder, the connected USB device,
or the iPod/iPhone contains a playable file.
Check whether the track is a playable file format.
Check whether the connected device is compatible with this
unit. (USB: page 29) (iPod/iPhone:
Ensure that the device contains files in the supported
formats. ( page 25)
Reattach the device.
Check the connection between this unit and iPod/iPhone.
Detach and reset the iPod/iPhone using hard reset. For
details on resetting the iPod/iPhone, refer to the instruction
manual supplied with the iPod/iPhone.
Check whether <IPOD SWITCH> setting is appropriate.
( page 9)
The skip limit has been reached.
No registered station in your iPod/iPhone.
No active station.
Pandora setup is not completed. Connect the iPod/iPhone to
this unit after completing the setup in your iPod/iPhone.
There are no stations found for the current song or artist.
You may not create more than 100 stations.
There is a problem creating a new station, such as a network
issue.
Troubleshooting
Remedy/Cause
page 11)
page 3)
page 23)
page 26)
ENGLISH | 27