Lewmar Pro-Serie Manuel D'installation, De Fonctionnement Et D'entretien page 10

GB
6- Operation
6.1 Manual controlled freefall
Use this method for quicker anchor deployment, in an emergency involving loss of power or to save battery
power. Observe maritime anchor deployment safety rules.
⚠ WARNING! Isolate (Turn off) the wind-
lass using circuit breaker / isolator.
6.1a - Pro-Fish
1
1. Disengage the capstan drive by pressing the plunger button on the capstan drive cap and pressing the locking
button until the plunger remains in the down position.
2. Release any anchor locks
3. When safe insert the Lewmar wrench in to the capstan drive cap. Rotate clockwise to grip the gypsy and
anticlockwise to free the gypsy controlling the rate of descent of the
anchor. Once deployed adjust desired scope if using a rope/chain, lock
the clutch by turning the drive cap clockwise and engage the anchor
locks. Remove the wrench handle.
4. To return the windlass back to powered operation pull the locking button out disengaging the plunger.
Engage the circuit breaker/isolator and press the UP/DOWN button.
6.1b - Pro-Series
1
1. Release any anchor locks
2. When safe, insert the Lewmar wrench in to the capstan drive cap. Rotate clockwise to grip the gypsy and an-
ticlockwise to free the gypsy controlling the rate of descent of the anchor. Lock the clutch by turning the drive
cap clockwise and engage the anchor locks.
3. To return the windlass back to powered operation lock the clutch by
rotating the capstan drive cap clockwise until tight and remove the
wrench handle.
4. Engage the circuit breaker/isolator and press the up button.
5. NOTE: If the clutch nut is not tight the internal clutch mechanism will rotate freely and not engage the drive to
the capstan.
See §6.3 for powered operation
10
2
2
⚠ WARNING! Trapping, crushing or
entanglement danger whiIst operating
windlass manually or under power
3
⚠ WARNING! Always remove
3
⚠ WARNING! Always remove
wrench handle after use
wrench handle after use
ON
4
4