Assembly; Assembling The Handle - CERTIFIED 060-0753-4 Guide D'utilisation

10
model no. 060-0753-4 I contact us: 1-844-428-7277

ASSEMBLY

CAUTION! Read complete INSTRUCTION MANUAL before operating this machine.
IMPORTANT! THIS LAWN MOWER IS SHIPPED WITHOUT OIL OR GASOLINE IN THE ENGINE.
Your new lawn mower has been assembled at the factory with the exception of those parts left
disassembled for shipping purposes. All parts, such as nuts, washers, bolts, etc., necessary to
complete the assembly have been placed in the parts bag. To ensure safe and proper operation of
your lawn mower, all parts and hardware you assemble must be tightened securely. Use the correct
tools as necessary to ensure proper tightness.
To remove lawn mower from carton
1. Remove loose parts included with mower.
2. Cut down two end corners of carton and lay end panel down flat.
3. Remove all packing materials except padding between upper and lower handle and padding
holding operator presence control bar to upper handle.
4. Roll lawn mower out of carton and check carton thoroughly for additional loose parts.

Assembling the handle

As shown in Figs. 3 and 4
IMPORTANT: Unfold handle carefully to avoid
pinching or damaging the control cables.
1. Insert the lower handle to the two side
brackets.
2. Fasten the lower handle to the device by
using two arc head bolts and two fixing
knobs on each side.
3. Unfold the upper handle and attach it to
lower handle by using two arc head bolts
and two fixing knobs on each side.
Fig. 3
Fig. 4