Makita DUR190U Manuel D'instruction page 13

Connect the hook of the shoulder harness to the hanger
and put the shoulder harness on. Make sure that the
tool is held securely by the shoulder harness.
DUR190U and DUR191U
2
1
► 1. Hook 2. Hanger
DUR190L and DUR191L
2
1
► 1. Hook 2. Hanger
Detachment
The shoulder harness features a means of quick
release.
DUR190U and DUR191U
1
► 1. Strip
Pull out the strip release the tool from the shoulder harness.
DUR190L and DUR191L
1
► 1. Buckle
Simply squeeze the sides of the buckle to release the
tool from the shoulder harness.
Correct handling of the tool
WARNING:
right-hand side. Correct positioning of the tool allows
for maximum control and will reduce the risk of seri-
ous personal injury.
WARNING:
control of the tool at all times. Do not allow the tool
to be deflected toward you or anyone in the work
vicinity. Failure to keep control of the tool could result
in serious injury to the bystander and the operator.
WARNING:
than 15m (50 ft) distance between operators when
two or more operators work in one area. Also,
arrange a person to observe the distance between
operators. If someone or an animal enters the
working area, immediately stop the operation.
CAUTION:
If the cutting tool accidentally
impacts a rock or hard object during operation,
stop the tool and inspect for any damage. If the
cutting tool is damaged, replace it immediately.
Use of a damaged cutting tool may result in serious
personal injury.
Correct positioning and handling allow optimum control
and reduce the risk of injury caused by kickback.
DUR190U and DUR191U
13 ENGLISH
Always position the tool on your
Be extremely careful to maintain
To avoid accident, leave more