Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.
Place handle between handle clamp and handle
holder. Adjust the handle to an angle that provides a
comfortable working position and then secure with hex
socket head bolts.
1
2
► 1. Hex socket head bolt 2. Handle clamp 3. Handle
holder
Mounting the attachment pipe
For DUR191U and DUR191L only
Mount the attachment pipe to the power unit.
1.
Turn the lever to the direction of the arrow shown
in the figure.
► 1. Lever
2.
Pull up the joint cover and insert the attachment
pipe while aligning the protrusion on the pipe (cutting
tool side) with the concave portion of the joint part.
1
► 1. Lock lever 2. Joint cover 3. Pipe
3
1
2
3
10 ENGLISH
Make sure that the surface of the lock lever is parallel to the pipe.
3.
Turn the lever to the direction of the arrow shown
in the figure.
► 1. Lever
To remove the pipe, turn the lever to the direction of the
arrow shown in the figure and pull the pipe out while
pressing down the lock lever.
1
► 1. Lever 2. Lock lever 3. Pipe
Installing the protector
WARNING:
Never use the tool without the
guard illustrated in place. Failure to do so can
cause serious personal injury.
CAUTION:
Take care not to injure yourself on
the cutter for cutting the nylon cord.
Attach the protector to the clamp using bolts.
2
► 1. Clamp 2. Protector 3. Cutter
1
2
3
1
3
Publicité
Table des Matières
