Installation Using The Screw Holes On The Side Of This Product - Pioneer AVIC-F860BT Manuel D'installation

Section
03 Installation
Flush surface screw
(5 mm × 9 mm)
(6 pcs.)
Installation using the screw
holes on the side of this product
% Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw holes
are aligned with the screw holes of the brack-
et, and tighten the screws at three locations
on each side.
Use either the truss head screws (5 mm ×
8 mm) or flush surface screws (5 mm ×
9 mm), depending on the shape of the brack-
et's screw holes.
22
Engb
If the pawl interferes with installation,
you may bend it down out of the way.
3
1 Factory radio-mounting bracket
2 Dashboard or console
3 Truss head screw or flush surface screw
Be sure to use the screws supplied with
this product.
1
2