Safety; Intended Use - Tecsis P3278 Mode D'emploi

2. Safety

2. Safety
WARNING!
Before installation, commissioning and operation, ensure that the appropriate
pressure sensor has been selected in terms of measuring range, design and
speciic measuring conditions.
GB
Non-observance can result in serious injury and/or damage to the equipment.
WARNING!
Open the connections only after the system has been depressurised.
Observe the working conditions in accordance with chapter 3 "Speciications".
Further important safety instructions can be found in the individual chapters of
these operating instructions.

2.1 Intended use

The pressure sensor is used to convert pressure into an electrical signal.
With hydrogen applications, use is only permitted when a medium and ambient tempera-
ture of 30 °C is not exceeded. For applications with direct contact with foodstuffs this
pressure sensor is not suitable.
The instrument has been designed and built solely for the intended use described here,
and may only be used accordingly.
The technical speciications contained in these operating instructions must be observed.
Improper handling or operation of the pressure sensor outside of its technical speciica-
tions requires the instrument to be taken out of service immediately and inspected by an
authorised tecsis service engineer.
The manufacturer shall not be liable for claims of any type based on operation contrary to
the intended use.
28 Operating instructions pressure sensor P3278