Beko WITV 8612 XW0R Manuel D'utilisation page 22

4.4 Maintenance and cleaning
Service life of the product extends and
frequently faced problems decrease if cleaned
at regular intervals.
4.4.1 Cleaning the detergent drawer
Remove any powder residue buildup in the
drawer. To do this;
C
INFORMATION
• If more than a normal amount of softener
and liquid detergent mixture starts to
remain in the softener compartment,
the siphon must be cleaned.
b. Wash the drawer and the siphon with plenty
of lukewarm water in a washbasin. Wear
protective gloves or use an appropriate
brush to avoid touching the residues in the
drawer when cleaning.
c. Replace the drawer into its housing after
cleaning. Check if the siphon is in its original
location.
4.4.2 Cleaning the loading
door and the drum
For products with drum cleaning programme,
please see Operating the product -
Programmes.
C
INFORMATION
• Repeat Drum Cleaning process
in every 2 months.
• Use an anti-limescale suitable
for the washing machines.
22 / EN
a. You can remove
the detergent
drawer by
pulling it towards
yourself strongly.
After every washing
make sure that no foreign
substance is left in the
drum.
If the holes on the bellow shown in the figure is
blocked, open the holes using a toothpick.
C
INFORMATION
• Foreign metal substances will cause
rust stains in the drum. Clean the
stains on the drum surface by using
cleaning agents for stainless steel.
Never use steel wool or wire wool.
A
WARNING
• Never use sponge or scrub
materials. These will damage the
painted and plastic surfaces.
4.4.3 Cleaning the body
and control panel
Wipe the body of the machine with soapy
water or non-corrosive mild gel detergents as
necessary, and dry with a soft cloth.
Use only a soft and damp cloth to clean the
control panel.
4.4.4 Cleaning the water intake filters
There is a filter at the end of each water intake
valve at the rear of the machine and also at
the end of each water intake hose where they
are connected to the tap. These filters prevent
foreign substances and dirt in the water to
enter the washing machine. Filters should be
cleaned as they do get dirty.
1. Close the taps.
Washing Machine / User Manual