JVC KD-X361BT Guide De Démarrage Rapide page 17

BLUETOOTH®
Depending on the operating system and the firmware version of your
mobile phone, Bluetooth features may not work with this unit.
Connect the microphone
Connect the supplied microphone to the microphone input jack on the rear
panel.
Adjust the
microphone
angle
Pair and connect a Bluetooth device for the first time
1 Press SRC-B to turn on the unit.
2
Search and select the name of your receiver ("KD-X3
Bluetooth device.
3
Perform (A) or (B) depending on what appears on the display.
For some Bluetooth devices, pairing sequence may vary from the steps
described below.
(A) "[Device Name]" "XXXXXX"
"XXXXXX" is a 6-digit passkey randomly generated during each pairing.
Ensure that the passkeys appear on the unit and Bluetooth device
are the same.
Press * ENTER to confirm the passkey.
Operate the Bluetooth device to confirm the passkey.
Secure using cord
clamps (not supplied)
if necessary.
BT") on the
"ENTER – YES" "BACK – NO"
(B) "[Device Name]" "ENTER – YES"
Press * ENTER to start pairing.
• If "PAIRING" "PIN 0000" scrolls on the display, enter the PIN code
"0000" into the Bluetooth device.
• If only "PAIRING" appears, operate the Bluetooth device to confirm
pairing.
"PAIRING COMPLETED" appears when pairing is completed and " " will light
up when the Bluetooth connection is established.
Answer a call
or * ENTER.
Press
• To adjust the phone volume [00] to [35], press VOL +/–.
• To end a call, press and hold
Audio player via Bluetooth
1 Press SRC-B repeatedly to select BT AUDIO.
• Pressing enters BT AUDIO directly.
2
Operate the audio player via Bluetooth to start playback.
To
Play back/pause
Select group or folder
Reverse skip/Forward skip
Reverse/Fast-forward
Repeat play
Random play
"BACK – NO"
or * ENTER.
On the faceplate
Press * ENTER.
Press 2 J / 1 K.
Press S / T.
Press and hold S / T.
Press 4 B repeatedly.
Press 3 A repeatedly.
9