Lamp Adjustment; Overhead Rigging - EuroLite TS-5 Mode D'emploi

During the operation, the lamp reaches temperatures of up to 600° C.
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
Procedure:
Step 1: Unscrew the fixation screws W, X, Y and Z of the lamp system and carefully remove it from the
housing.
Step 2: If replacing the lamp, remove the old lamp from the lamp holder.
Step 3: Insert the lamp into the lamp holder.
Step 4: Replace the lamp system in the housing and tighten the fixation screws.
Step 5: Adjust the lamp as described under lamp adjustment.

Lamp adjustment

Remove the transportation protection at the mirror before operating this device!

Overhead rigging

Please consider the EN 60598-2-17and the respective national standards during the installation!
The installation must only be carried out by an authorized dealer!
Do not operate this device with opened cover!
The lampholder is aligned at the factory. Due to
differences between lamps, fine adjustment may
improve light performance.
Strike the lamp, set the dimmer intensity to 100 %
and focus the light on a flat surface (wall). Center
the hot-spot (the brightest part of the beam) using
the 3 adjustment screws "A, B, C". Turn one
screw at a time to drag the hot-spot diagonally
across the projected image. If you cannot detect a
hot-spot, adjust the lamp until the light is even.
To reduce a hot-spot, pull the lamp in by turning all
three screws "A, B, C" clockwise ¼-turn at a time
until the light is evenly distributed.
If the light is brighter around the edge than it is in
the center, or if light output is low, the lamp is too
far back in the reflector. "Push" the lamp out by
turning the screws "A, B, C" counterclockwise ¼-
turn at a time the light is bright and evenly
distributed.
DANGER TO LIFE!
23/57 00026361.DOC, Version 1.3