Lamp Adjustment; Focusing - EuroLite FS-600 GKV Profile Spot Mode D'emploi

Lamp adjustment

The lampholder is aligned at the factory. Due to differences between lamps, fine adjustment may improve
light performance.
Strike the lamp, open the shutter and the iris, set the dimmer intensity onto 100 % and focus the light on a
flat surface (wall). Center the hot-spot (the brightest part of the beam) using the 3 adjustment screws "A, B,
1
CAUTION, HOT LAMP!
Let the lamp cool down for
10 min. Change the lamp by
loosening screws X and Y.
Adjust the lamp position by
turning screws A, B and C.
B

Focusing

Step 1: Loosen the focus button on the underside of the device.
Step 2: Adjust the focus by sliding the lenshousing forward or backward.
Step 3: Tighten the focus button.
Do not operate this device with opened lamp housing!
A
2
C
Beam focus knob
18/39
C". Turn one screw at a time to drag the hot-
spot diagonally across the projected image. If
you cannot detect a hot-spot, adjust the lamp
until the light is even.
To reduce a hot-spot, pull the lamp in by turning
all three screws "A, B, C" clockwise ¼-turn at a
time until the light is evenly distributed.
If the light is brighter around the edge than it is
in the center, or if light output is low, the lamp is
too far back in the reflector. "Push" the lamp out
by turning the screws
counterclockwise ¼-turn at a time the light is
bright and evenly distributed.
"A, B, C"
40002500_V_1_2.DOC