Installation; Installing/Replacing The Lamp; Danger To Life - EuroLite FS-600 GKV Profile Spot Mode D'emploi

INSTALLATION

Installing/Replacing the lamp

Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
During the operation, the lamp reaches temperatures of up to 800° C.
For the installation, you need a HX600 GKV 240V/600W G-9.5 lamp.
Procedure:
Step 1: Unscrew the knurled screw of the lamp housing.
Step 2: Remove the lamp housing from the device.
Step 3: If replacing the lamp, remove the old lamp from the socket.
Step 4: Insert the HX600 GKV 240V/600W G-9.5 lamp into the lamp-socket.
Step 5: Replace the lamp housing onto the device and tighten the screw.

DANGER TO LIFE!

Only install the lamp with the device switched off!
Unplug from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
17/39 40002500_V_1_2.DOC