Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OVERVIEW
INSTALLATION
Installing/Replacing the lamp
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need one Cool-Beam 12 V GX-5.3 lamp with up to max. 50 W.
Procedure:
Step 1: Open the housing cover by pulling the extension spring.
Step 2: If replacing the lamp, remove the old lamp from the spot.
Step 3: Place the new Cool-Beam 12 V/ 50 W GX-5.3 lamp into the lamp socket.
Step 4: Close the device.
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
10
(1) Colour filter frame
(2) Tube
(3) Mounting-bracket
(4) Hole for safety rope
(5) Extension spring
(6) Housing cover
(7) Mounting bracket screws
(8) Clip-to-hold clamps
Publicité
Table des Matières
