Installation; Installing/Replacing The Lamp; Overhead Rigging - EuroLite BLACK GUN UV-Spot Mode D'emploi

If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, lamp explosion, crash etc.

INSTALLATION

Installing/Replacing the lamp

Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need one E-40/400 W HQV-400 UV lamp.
During the operation, the lamp reaches temperatures of up to 600° C.
Procedure:
Step 1: Unscrew the fixation screws of the protective grid.
Step 2: Remove the protective grid.
Step 3: If replacing the lamp, remove the old lamp from the lamp-socket.
Step 4: Insert the E-40/400 W HQV-400 UV lamp into the lamp-socket.
Step 5: Replace the protective grid and tighten the screws.

Overhead rigging

The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
Do not operate this device with opened protective grid!
14/31 00025937.DOC, Version 4.0