Connection With The Mains; Operation; Stand Alone Operation; Dmx-Controlled Operation - EuroLite SL-1200 LD Mode D'emploi

Connection with the mains

The electric connection must only be carried out by a qualified electrician!
In order to connect the device to the mains, you have to install a power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Connect the device to the mains with the power-plug.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the SL-1200 LD starts running. During the Reset, the motors are
trimmed and the device is ready for use within approximately 20 seconds.
Move the objective-lens for adjusting the focus in order to obtain a sharp projection.

Stand Alone operation

In the Stand Alone mode, the SL-1200 LD can be used without controller.
Disconnect the SL-1200 LD from the controller and set all DIP-switches to Off.
Please note: If you wish to change from one operating mode into another, you either have to switch off the
lamp/activate Blackout-mode or unplug the projector from the mains and plug it again.

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
DANGER TO LIFE!
International
L
N
26/55 00020554.DOC, Version 1.4