Addressing; Connection With The Mains; Operation; Sound-Control/Master/Slave-Operation - EuroLite TC-3 Mode D'emploi

Addressing

Each projector occupies 1 channel. To ensure that the control signals are properly directed to each projector,
the projector requires adressing. This is to be done for every single projector by changing the DIP switches
as set out in this table.
The starting address is defined as the first channel from which the TC-3 will respond to the controller.
Please make sure that you don't have any overlapping channels in order to control each TC-3 correctly and
independently from any other fixture on the DMX data link. If two, three or more TC-3 are addressed
similarly, they will work similarly.
Occupation of the DIP-switches:
Setting the DMX-
starting address:
Projector number
& channels
Projector 1 - channel 1
Projector 2 - channel 2
Projector 3 - channel 3
Projector 4 - channel 4
Projector 5 - channel 5

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
In general, lighting effects should not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the TC-3 starts running. During the Reset, the motors are
trimmed and the device is ready for use within approximately 20 seconds.

Sound-control/Master/Slave-operation

The lamp is automatically ignited as soon as the condensor microphone receives music signals. If the
projector does not react to the music signals, the microphone sensitivity is too low. You can adjust the
sensitivity with the rotary-control on the rearpanel.
You can do without a controller as the TC-3 features a built-in microphone, which provides automatic sound
control.
1
DIP-switch no.
1
Starting address
On
Off Off
On
Off
On
Off
On
Off
On
Off
International
L
N
2 3 4 5 6
16
2 4 8 32
22
7 8 9
64 128 256